Evco c-pro micro SAVE Bedienungsanleitung PDF herunterladen (Seite 33)

C-PRO MICRO SAVE APPLICATION MANUAL

Page 33

6 REGULATIONS

6.1 State of the unit

There are several unit switch-on/off procedures:

1) Via the relevant ON/OFF key

Switch-ON: press the relevant key for about 2 seconds, if all the conditions are fulfilled the

unit starts working (“ON” mode).

Switch-OFF: press the relevant key for about 2 seconds, the unit stops working (“OFF”

mode).

2) Using the Start/Stop from digital input control (parameter, PH05=1)

Switch-ON: close the contact, if all the conditions are fulfilled the unit starts working (“ON”

mode).

Switch-OFF: if the contact is open the unit stops working (“OFF from Start/Stop” mode).

3) Via Supervision protocol (parameter, PH06=1)

Switch-ON: activate the switch-on state from protocol, if all the conditions are fulfilled the

unit starts working (“ON” mode).

Switch-OFF: if deactivated by switch-on state protocol the unit stops working (“OFF from

Supervisor” mode).

The ON/OFF status from key has priority with respect to the other two. In fact the ON/OFF states

by digital input and supervision protocol can only be reached with machine in “ON” mode.

A machine switched-off by Start/Stop digital input can:

⋅ pass to the OFF state from key (by pressing ESC).

⋅ pass to the OFF state from supervisor if the OFF condition from digital input returns and the

OFF state is set by supervisor.

⋅ ass to the ON state if the ON condition from digital input returns and the OFF state is not set

by supervisor.

A unit switched-OFF by supervision protocol can:

⋅ Move to the OFF state by key (by pressing ESC key).

⋅ Move to the OFF state from digital input if the OFF condition from supervisor ceases and

the OFF state from digital input is triggered.

⋅ Move to the ON state if the OFF condition from supervisor ceases and the OFF state is not

present from digital input.

The unit ON/OFF key is the ESC key pressed for about 2 seconds.

The remote Start/Stop input (when present) can be configured using the parameters:

- PH05: Enables the function

- PH52: Sets the NC, NO logic for the digital contact

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 53 54

Keine Kommentare

Evco c-pro micro SAVE Bedienungsanleitung Seite 33